I tried to imagine the sort of custom instrument preamp that a top session player might have brought to a studio in The Seventies. Similar in principle to an Alembic F2B (part of many top players’ rigs for decades) but with many crucial improvements, this compact all-tube preamp starts with a classic Fender blackface low/mid/high/bright/vol feature set but adds the following: *master volume, *hi shift, and most importantly an additional output stage that can reliably drive a 10k input at high levels with no frequency loss.
I learned a ton about the idiosyncratic Fender eq circuit by listening and fine-tuning this unit; the various compromises and ‘sweet spots’ that one can find with different cap and pot values. Basic three-stage filter power supply (output stage at 2nd leg) and c/t grounded AC heaters proved more than sufficient; the thing runs dead quiet (zero hum) other than a minuscule bit of reassuring hiss, as i used all NOS 1960s Allen Bradley carbon-comp resistors throughout (which id never do for a mic pre, but for vintage guitar/bass tone its part of the package, i think). The output stage runs at 350 volts, and the input and makeup stages are around 215, allowing for tons of headroom.
Above: the unit with the top cover removed. You can see the sub chassis with the 12AX7 and the 6C4 output driver; a huge Aerovox output cap; and the rugged fiberglass turret-board point-to-point construction.
Above: another internal view. All of the hardware bits are DakaWare, API, and Smith NOS parts from the 60s and 70s, all from my inventory. Signal wiring (orange) is stranded silver 22ga wire and the ground wire (green) is 18ga solid copper.
How does it sound? With bass guitar its absolutely magical- every classic electric bass sound is just there at your fingertips; very inspiring to play thru. Really sounds like a ‘finished’ bass track with no additional processing. The whole package is compact enough to fit in many gig bags. As for the name? “Super” as the circuit owes much to my beloved Fender Super Reverbs, and “Hugh” as an homage to one of my all-time favorite session greats Hugh McCracken.
Starting this month I am scaling back the monthly WPKN FM radio show to one…
Im back from 2 weeks in Japan, time that I primarily spent hunting for records.…
Available now on LoveAllDay Records : the new LP "Secular Music Group Volume 1"- avail on vinyl…
This month's Preservation Sound Radio program will air tonight Tuesday May 21 at 8:30 PM.…
This month on Preservation Sound Radio: nine side-filling tracks from 1970 thru 1986, all from…
This month's show airs Tuesday 2.20.24 at 8:30PM -11:25PM EST on WPKN 89.5 FM in…
View Comments
Would you be willing or able to post a schematic for this? Would love to try this build myself!
Also, no input/output transformers? Can't see any from the pictures.
Hi. nope no transformers. Next one i build i will try a 15K:600 output, selectable tho, as it will cut a lot of level. I dont have a schematic for this or anything that i build. it's all in my head. Start with a Fender Super Reverb preamp section, add a cathode-follower output stage from RCA RC20 and a basic liner power supply and then experiment to find the part values that you like the best. Good luck.
Hi,
Is it possible to purchase one of these?
Hello. Potentially yes. I've built two and those are sold. Eventually I will likely make one or two more. If you want a shot at one of them, the best thing is to follow my Instagram (@preservationSound) as any availabilities will be announced there. Thank you for your interest.
Nice looking build!
Where do you get your cases?
Cheers
I believe the box is a BUD. The handles may be BUD as well, I can't recall.